The DS/DSA are quad line receivers Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet. The DS/DSA are quad line receivers designed to .. Reproduction of TI information in TI data books or data sheets is permissible. D Input Resistance 3 kΩ to 7 kΩ. D Input Signal Range ±30 V. D Operate From Single 5-V Supply. D Built-In Input Hysteresis (Double. Thresholds).
|Published (Last):||16 June 2017|
|PDF File Size:||16.40 Mb|
|ePub File Size:||5.45 Mb|
|Price:||Free* [*Free Regsitration Required]|
They are constructed on a single monolithic silicon chip. They feature a factor of ten increase in speed over general purpose devices without sacrificing DC performance.
DNational Semiconductor. The TL contains two error amplifiers, an internal oscillator externally adjustablea dead-time control DTC comparator, a pulse-steering flip-flop, a 5-V precision reference, undervoltage lockout control, and output control circuits.
Quad Line Receiver
However, unlike most internally compensated amplifiers, external frequency compensation may be added for optimum performance. Features es1489 TTL input compatible n Typical propagation delays: Further, a single capacitor can be added to reduce the 0. All inputs are protected against damage due to electrostatic discharge by diodes to VCC and ground. This enables the construction of serial and terminal interfaces while maintaining minimal power consumption.
Posted by Datasheet datqsheet Differential analog voltage inputs allow increasing the common-mode rejection and offsetting the analog zero input voltage value.
Monday, March 17, tl TI datasheet download pdf.
DS Datasheet(PDF) – National Semiconductor (TI)
Share to Twitter Share to Facebook. SPiKe protection means that these parts are safeguarded at the output against overvoltage, undervoltage, overloads, including thermal runaway and instantaneous temperature peaks. Posted by Datasheet at 5: The outputs share a common source supply and common power ground terminals, which allow system designers to eliminate errors caused by high current-induced voltage drops and common-mode noise.
The LM series has internal unity gain frequency compensation. In addition, the voltage reference input can be adjusted to allow encoding any smaller analog voltage span to the full 8 bits of resolution. Overcompensation can be used with the amplifier for greater stability when maximum bandwidth is not needed. This device has enable and disable circuitry common to all four drivers. LNational Semiconductor.
ANational Semiconductor. This part uses special output circuitry that enables the drivers to power down without loading down the bus. This considerably simplifies its application since no dz1489 components are necessary for operation. Designed primarily for power-supply control, the TL provides the systems engineer with the flexibility to tailor the power-supply control circuits to a specific application. Two totem-pole outputs provide exceptional rise- and fall-time performance for power FET control.