QS – read user manual online or download in PDF format. Pages in total: Preface This document is intended to assist the service technician in the operation, maintenance and repair of the QS Series 64 Voice Synthesizer/ Controller. QS7/QS8 Reference Manual 1 2 QS7/QS8 Reference Manual Table of Contents Contents 1: Setting Up 7 Unpacking and Inspection 7 AC Power 7 Line.

Author: Nijind Voodoojin
Country: Serbia
Language: English (Spanish)
Genre: Environment
Published (Last): 20 July 2005
Pages: 196
PDF File Size: 11.33 Mb
ePub File Size: 2.35 Mb
ISBN: 411-7-58383-295-6
Downloads: 93362
Price: Free* [*Free Regsitration Required]
Uploader: Mazugal

By connecting an expression pedal to the [PEDAL 1] jack, you can use the pedal to change the volume or tone or some other quality such as reverb depth or vibrato speed of the sound, if the Program is edited to use the pedal s. About Modulation Modulation modifies some aspect of a sound over time. When using the Stereo Delay, page 5 lets you adjust the feedback level of the left channel, while page 8 lets you adjust the same for the right channel.

Alesis QS7 Reference Manual

This setup of parameters can mabual stored so that you can get back to it instantly at the touch of a button. Related Manuals for Alesis QS7. The product should only be used with a rack which the manufacturer recommends.

If a long attack is set, and the envelope does not reach the end of the attack segment when the note is released, it will be skipped and the envelope will jump immediately to the sustain decay segment. The parameter definitions of the remaining bits of the first byte as well as the remaining 84 bytes of the sound are determined by this bit.


In the example above, MIDI channel 1 is selected. This manua, be further enhanced in Mix Mode by using the Range function in Mix Edit Mode to cap-off the low and high limits. Pitch input level Lower the Input Filter value to remove high frequencies from the input signal before they go into the Reverb.

With the header, the total number of bytes transmitted with a program dump is Note that qs.1 delay signal may already have passed through the Pitch module, depending on the Input settings of the Delay module. For example, if you have assigned a Closed Hat and an Open Hat to two different notes, playing either note should cut-off the other if it had recently been played.

Density 00 to 99 Page 13 Page 12 if Gated or Reverse type Density controls how the first reflection of the reverb effect will appear.


Chapter 4 Mix Edit Mode lets you change the parameters of an existing Mix. Your First Session Storing an Edited mix Once you have made changes to a Mix, you will need to store the Alesiis into the User Bank; that is, if you want to keep the changes you have made.

Page 50 Program or Effects modulation destinations, or you can simply allow the MIDI controller of your choice to do it for you. Since multiple keyboards can take up excessive space, the obvious solution is a rack mount sound engine without keys.


ALESIS QS7.1 User Manual – Download

These changes are outlined in Appendix A. This makes for bigger and smoother sounding Reverb settings. For a aleis representation of these waveforms and additional discussion on how to use the LFOs, see the diagrams and notes on page Send 3 reverb input 1 See page for more information about the Serial jack.

Send 2 reverb input 2 Note that certain controllers such as pitch bend and aftertouch will send on all channels at once.

Channel 5 parameters When you select a Mix from memory, it is copied janual the Mix Edit buffer, the 16 Programs of that Mix are copied into the 16 edit buffers, and the Effect from one of the 16 Programs is copied into the Effects buffer.

When disabled, no sound will be heard. Note that the stacking of Programs in Mix Play Mode aleais in addition to any sounds that may be stacked in the four sound layers of each Program. Filter Frequency 00 to 99 Page 1 This sets the filter’s initial cutoff frequency.

Alesis QS user manual – – Solve your problem

For more information, see page The following three parameters only appear if the Pitch type is set to Pitch Detune or Resonator, respectively. Amp LFO set to a triangle wave gives tremolo effects. Here is a block diagram of a sound in Drum Mode.